Stone and Concrete Oil 254

Öle und Wachse

For surface treatment of all types of concrete and stoneware, indoors.

Application range: 

For impregnating and maintaining all absorbent tiles and concrete surfaces, such as terracotta etc.

Technical qualities: 

Protects against general soiling, grease and oil. Suitable as joint protection for cement joints. Water-repellent and abrasion-resistant, does not noticeably stain the surface. Can be used indoors.



Full declaration: 

Wood oil, linseed oil, ricin oil, sunflower oil, natural resin ester, isoparaffins, drying agents. The VOC content of this product is max. 420 g/l. The EU limit value is max. 700 g/l (category f from 2010).


Stir carefully before use. Apply with a brush, cloth, roller or sponge. The surface must be dry, clean and free of grease and dust. Apply the stone oil with a brush or roller. After a penetration time of approx. 20-30 minutes, remove any excess oil from areas that are still absorbent and polish the surface dry with a cloth or pad. Apply another thin coat the next day and apply as described above. If necessary, apply a 3rd coat depending on the absorbency of the substrate. Important: No oil layer must remain on the surface!

Drying time: 

Dry and recoatable after 4 - 6 hours (18 - 22°C / 50 - 55% relative humidity). Complete drying takes approx. 7 - 10 days.

Container sizes and coverage: 

20 - 50 ml/m2 depending on the absorbency of the substrate.

0.75l21.5 m2
2.5l71.5 m2
2,5l63 m2

* Coverage per coat



Store cool and tightly closed. If a skin forms, remove it before reuse. Sieve oil if necessary.


In accordance with local, official regulations. Dried product residues can be disposed of with household waste. Waste code: EWC 08 01 11


Clean with pH-neutral cleaning agent in lukewarm water.

Hazard statements: 

Safety data sheet available on request.

Precautionary statements: 
Keep out of the reach of children. IF SWALLOWED: Immediately call a POISON CENTRE/doctor. DO NOT induce vomiting. Avoid release to the environment. Dispose of contents/container for proper recycling. 
Work materials soaked with product, such as cleaning cloths, sponges, sanding dusts, etc. with oil that is not completely dry, should be stored in an airtight metal container or in water and then disposed of, as otherwise there is a risk of spontaneous combustion due to the vegetable oil content. The product itself is not self-igniting. Ensure adequate ventilation during drying. Due to the natural raw materials used, a typical odour may occur. Wear approved respiratory protection when using spraying equipment. Wear a fine dust mask when sanding.